Panasonic KX-TG2258PW Manual De Usuario

 

The unit does not work.

• Check the settings (p. 8–9).
• Check whether the dialing mode setting is 

correct (p. 13).

• Charge the battery fully (p. 8).
• Clean the charge contacts and charge again 

(p. 9).

• Install the battery properly (p. 8).
• Place the handset on the base unit and 

unplug the AC adaptor to reset it. Plug in, and 
try again.

• Re-install the battery (p. 8) and charge it fully.

The unit does not announce 
the displayed caller’s name.

• The handset and base unit ringer volumes 

are OFF (p. 17).

• The Talking Caller ID feature is OFF (p. 15).

The unit does not announce 
the displayed caller’s name 
properly.

• Name pronunciation may vary. Name 

pronunciation quality is based on names 
most commonly used in the United States.

• The unit will announce each letter of 

abbreviations, such as Co., Inc., etc.

• Caller ID service supports names of up to 

15 letters. If the caller’s name has more than 
15 letters, the name will not be announced 
correctly.

Previously programmed 
information is erased.

• If a power failure occurs, programmed 

information may be erased. Reprogram if 
necessary.

“

 

Recharge battery

 

” is 

displayed, “

” flashes or 

the unit beeps intermittently.

• Charge the battery fully (p. 8).

You charged the battery fully, 
but “

 

Recharge battery

 

” is 

still displayed and/or “

” 

continues to flash.

• Clean the charge contacts and charge again 

(p. 9).

• Install a new battery (p. 8).

The IN USE/CHARGE 
indicator light does not go out 
after the battery has been 
charged.

• This is normal.