Panasonic KX-TCD700BX Manual De Usuario
31939_KX-TCD700CX_Czech 18/6/01 1:54 pm Page 51
48
Problem
Remedy
While programming or searching,
• To answer the call, lift the handset or
Z O
.
the unit starts to ring and stops
•
Start again from the beginning after hanging up.
the program/search.
The unit does not display the
• Other telephone equipment may be interfering with
caller’s phone numbers.
•
your phone. Disconnect them and try again.
• Other electrical appliances connected to the same
outlet may be interfering with the Caller ID
information. Telephone line noise may be affecting
the Caller ID information.
information. Telephone line noise may be affecting
the Caller ID information.
Ï
does not function.
• The handset is too far from the base unit.
• The handset is engaged in an outside call.
• The handset is engaged in an outside call.
You cannot redial.
• If the last number dialled was more than 24 digits
long, the number will not be redialled correctly.
The paged handset does not
• The handset is not in the same radio area.
answer.
• The handset is engaged in an outside call.
• The handset has been cancelled or has not been
• The handset has been cancelled or has not been
registered. Register the handset to the base unit
(p.36).
(p.36).
The unit misdials when connected
• Check the pause function (p.25).
to a PBX.
You cannot register the handset
• The base unit has registered a maximum of 6
in the base unit.
•
handsets or the handset has registered a maximum
of 4 base units.
of 4 base units.
• A wrong base unit password was entered. Enter the
correct password.
• There is interference from other electrical units,
locate the handset and base unit away from them.
• You must finish registration within 1 minute after the
ringer tone sounds, or programming will be
cancelled (p.36).
cancelled (p.36).
The battery strength is not
• Check that the battery type selection is correct
displayed correctly.
•
(p.34).
➡
While using the intercom, two tones
• A call is being received. To answer, Z P then
sound.
•
O
.