Panasonic KX-TCD440AL Manual De Usuario
37
Useful Information
redialled. Redial the number manually.
The handset beeps intermittently and/or
074
074
flashes.
L
Fully charge the batteries (page 9).
I fully charged the batteries, but 074
still flashes.
still flashes.
L
Clean the charge contacts and charge
again (page 9).
again (page 9).
L
It is time to replace the batteries (page
10).
10).
7
disappears and the unit stops
charging when the handset is on the
base unit.
base unit.
L
Nickel cadmium batteries are inserted
when the battery type is set to “NI-MH”.
Change the battery type setting to “NI-
CD
when the battery type is set to “NI-MH”.
Change the battery type setting to “NI-
CD
” (page 23).
Caller information is not displayed.
L
You must subscribe to Caller ID service.
While viewing caller information, the
display returns to standby mode.
display returns to standby mode.
L
Do not pause for over 60 seconds while
searching.
searching.
I cannot register a handset to a base unit.
L
The maximum number of base units (4)
are already registered to the handset.
Cancel unused base unit registrations
from the handset (page 33).
are already registered to the handset.
Cancel unused base unit registrations
from the handset (page 33).
L
The maximum number of handsets (6) are
already registered to the base unit. Cancel
unused handset registrations from the
base unit (page 33).
already registered to the base unit. Cancel
unused handset registrations from the
base unit (page 33).
L
You entered the wrong PIN number. If you
forget your PIN, consult your nearest
Panasonic service centre.
forget your PIN, consult your nearest
Panasonic service centre.
L
Locate the handset and the base unit
away from other electrical appliances.
away from other electrical appliances.
Answering system
(KX-TCD445 only)
(KX-TCD445 only)
The answering system is turned on, but
caller messages are not recorded.
caller messages are not recorded.
L
The recording time is set to “GREET
ONLY
ONLY
”. Select “1 MINUTE” or
“UNLIMITED” (page 31).
L
Message memory is full. Erase
unnecessary messages (page 28).
unnecessary messages (page 28).
I cannot operate the answering system
with the handset.
with the handset.
L
Another handset user is using the
answering system or changing base unit
settings. Wait for the other user to finish.
answering system or changing base unit
settings. Wait for the other user to finish.
L
A caller is leaving a message. Wait for the
caller to finish.
caller to finish.
L
The handset is too far from the base unit.
Move closer.
Move closer.
I cannot operate the answering system
remotely.
remotely.
L
You are entering the wrong remote
access code. Turn remote operation on
using the handset and select a new code
(page 29).
access code. Turn remote operation on
using the handset and select a new code
(page 29).
L
You are pressing the dial keys too quickly.
Press each key firmly.
Press each key firmly.
L
The answering system is turned off. Turn
it on (page 27, 30).
it on (page 27, 30).
L
You are using a pulse telephone. Try
again using a touch tone phone.
again using a touch tone phone.
While recording a greeting message or
listening to messages, the unit rings and
recording stops.
listening to messages, the unit rings and
recording stops.
L
A call is being received. Answer the call
and try again later.
and try again later.
TCD440_445AL(E).book Page 37 Monday, May 24, 2004 1:17 PM