Brocade Communications Systems 12.4.00a Manual De Usuario

Configuring HTTP TRL

1

•

Rate-limiting functionality must support rate over time and total connections, based on 
customer ID.

•

Max-conn currently works only for HTTP1.0.

•

This feature supports http redirect, or drop client response actions once rate-limit has been 
exceeded.

•

This feature provides event and threshold alert monitoring and notification, based on specific 
customer connection SLAs.

Configuring HTTP TRL 

This section describes how to configure the HTTP TRL feature.

NOTE

For traffic going through a VIP, Brocade recommends that you apply the TRL policy to the VIP and 
Interface. 

Configuring HTTP TRL client 

Use the following procedures to configure the HTTP TRL client rate limit and the client maximum 
connection.

Configuring HTTP TRL client rate limit

To configure the HTTP TRL client rate limit, follow these steps.

1. Define an HTTP TRL policy.

ServerIronADX(config)# http-trl-policy p1

Syntax: [no] http-trl-policy <policy-name>

2. Configure an HTTP TRL client rate limit. 

ServerIronADX(config-http-trl-p1)# client-name c1 monitor-interval 1 10 20 0

Syntax: [no] client-name <client-name> monitor-interval <interval-value> <warning-rate> 

For more detailed command information, refer to 

 on page 27.

3. Configure the action to take if a client exceeds the configured rate limit (optional).

ServerIronADX(config-http-trl-p1)# client-name c1 exceed-action reset

Syntax: [no] client-name <client-name> exceed-action reset

Configuring HTTP TRL client maximum connection

To configure HTTP TRL client maximum connection, follow these steps.

1. Define an HTTP TRL policy.

ServerIronADX(config)# http-trl-policy p1