Brocade Communications Systems 12.4.00 Manual De Usuario

Enabling DNS request logging

1

Enabling the distributed health check feature for an individual site ServerIron ADX

You can enable the distributed health check feature for an individual site ServerIron ADX. Enter the 
commands such as the following on the GSLB ServerIron ADX, not on the site ServerIron ADX.

GSLB-ServerIronADX(config)# gslb site sunnyvale



GSLB-ServerIronADX(config-gslb-site-sunnyvale)# si-name abc 1.1.1.107 

enable-si-dist-health-check

Syntax: [no] si-name [<name>] <ip-addr> enable-si-dist-health-check

Disabling or re-enabling distributed health check

You can disable the distributed health check feature for an entire GSLB site. When you do this, it 
applies to all the site ServerIron ADXs at that site. Note that if there is a configuration to enable or 
disable the distributed health check feature on an individual site ServerIron ADX (Refer to 

and 

page 106), the configuration on the individual ServerIron ADX takes effect for that site ServerIron 
ADX and overrides the site configuration for that site ServerIron ADX

To disable distributed health checks for a site, enter commands such as the following, enter the 
commands on the GSLB ServerIron ADX, not on the site ServerIron ADX:

GSLB-ServerIronADX(config)# gslb site sunnyvale



GSLB-ServerIronADX(config-gslb-site-sunnyvale)# no-distributed-health-check

Syntax: [no] no-distributed-health-check

To re-enable distributed health checks for the site, enter the following command.

GSLB-ServerIronADX(config-gslb-site-sunnyvale)# no no-distributed-health-check

Clearing the distributed health check settings for a site ServerIron ADX

You can clear the distributed health check settings for a site ServerIron ADX. When you clear the 
settings, the site ServerIron ADX inherits the settings configured for the site itself. (Refer to 

 on page 106.) If you have not configured 

distributed health check settings for the site, then the distributed health check feature is enabled 
for the site ServerIron ADX. This is the default setting for the feature.

To clear the distributed health check settings from a site ServerIron ADX, enter commands such as 
the following on the GSLB ServerIron ADX, not on the site ServerIron ADX.

GSLB-ServerIronADX(config)# gslb site sunnyvale



GSLB-ServerIronADX(config-gslb-site-sunnyvale)# si-name 1.1.1.107 

clear-si-health-check-mech

Syntax: [no] si-name [<name>] <ip-addr>clear-si-health-check-mech

Configuring the health status reporting interval

If the GSLB ServerIron ADX supports the distributed health check feature, then you can globally 
configure the interval at which the distributed health check site ServerIron ADXs report the health 
check information to the GSLB ServerIron ADX for the GSLB distributed health check feature. Note 
that if health status interval is configured globally, it applies to all peer site ServerIron ADXs that 
support the distributed health check feature.