Hitachi 32LD6600A Manual De Usuario
- 8 -
Before Switching On Your TV
Power Connection
IMPORTANT: The TV set is designed to op-
erate on 220-240V AC, 50 Hz.
After unpacking, allow the TV set to reach the
After unpacking, allow the TV set to reach the
ambient room temperature before you con-
nect the set to the mains.
Connections To The Aerial Input
Socket
9+)8+)
:
5($52)7+(79
&$%/(79
Connect the aerial or cable TV plug to the
Aerial input socket located at the rear of the
TV and connect the cable plug coming out
from the TV out socket located on the de-
vices (VCR, DVB etc.) to this socket as well.
How To Connect Other Devices
IMPORTANT: Switch off the TV before con-
necting any external device.
Sockets for external connections are at the
Sockets for external connections are at the
rear and right side of the TV. For connection
of other devices via Scart refer to the manu-
als of the related devices.
Inserting Batteries In The Remote
Control Handset
Remove the battery cover located on the
back of the handset by gently pulling down-
wards from the indicated part.
Insert two AA/R6 or equivalent type batteries
inside. Place the batteries in the right direc-
tions.
Replace the battery cover.
NOTE: Remove the batteries from remote
control handset when it is not to be used for
a long period.Otherwise it can be damaged
due to any leakage of batteries.
Switching The TV ON/OFF
To switch the TV on:
Your TV will switch on in two steps:
1- Connect the power supply cord to the sys-
1- Connect the power supply cord to the sys-
tem. Press Power On/Off switch located
by the mains input socket. Then the TV
switches itself to stand-by mode and the led
on the front of the TV becomes Red.
2- To switch on the TV from stand-by mode
either:
Press a digit button on the remote control so
that a programme number is selected,
or,
Press the "+P/CH" or "P/CH-" button at the
or,
Press the "+P/CH" or "P/CH-" button at the
top of the TV or press the P- or P+ but-
ton on the remote control, so that last mode
switched off is selected.
By either method the TV will switch on and
By either method the TV will switch on and
the led becomes green.
To switch the TV off:
Press the (stand-by) button on the re-
mote control or at the top of the TV, so the TV
will switch to stand-by mode and the GREEN
LED will become RED.
To power down the TV completely, press
Power On/Off button at the rear side of the
TV,
or,
or,
01-ENG-32705W-CLE967 UK-HITACHI 32 INCH TFT-TRIDENT-(SAM)-50076727.p65
20.10.2005, 09:56
8