Cobra Electronics CXR925 Manual De Usuario

charger:
1. Insert radio(s) into desktop charger as shown. 
2.  Insert round connector of 120-volt adapter 

into jack on back of charger.

3.  Plug 120-volt adapter into electrical outlet.
If charging light is not on, check position of radio. 

Radio should be upright. The charge 

indicator light will stay on as long as the radio is in the charging 

well and the battery pack is charging. After the battery pack is fully 

charged, the charge indicator light will turn off. 
It normally takes about 15 hours to fully recharge battery pack.  

Battery pack will not be damaged if it stays in the charging well 

longer than that. 

To charge a single radio, you can bypass the desktop 

charger and simply insert the wall adapter’s round 

connector directly into the speaker/microphone/charge 

jack located on the top of the radio. 

Use only the supplied rechargeable batteries and charger for 

recharging your Cobra microTALK

®

 radio. 

Cobra recommends your radio is turned off while being charged.

Press and hold the Power button until you 

hear a series of audible tones indicating the  

radio is on.
Your microTALK

®

 radio is now in Standby 

mode, ready to receive transmissions. The radio 

is always in Standby mode, except when the 

Talk, Call, Mode or Power buttons are pressed.
Battery Low 

When battery power is low, the Battery Low icon 

will blink. Your batteries should be recharged.
Auto Battery Save 

 Your microTALK

®

 radio has a unique circuit 

designed to extend battery life. If there are  

no transmissions for 10 seconds, the radio will 

automatically switch to Battery Save mode and 

the Power Saver icon will flash in the display. 

This will not affect the radio’s ability to receive 

incoming transmissions.
Communicating with Another Person  •

1. Press and hold the Talk button.
2.  With the microphone about 2 inches 

(5 cm) from your mouth, speak in a  

normal voice.

3.  Release the Talk button when you are 

finished talking and listen for a response.

You cannot receive incoming calls while  

pressing the Talk button.

Both radios must be tuned to  

the same channel/privacy code  

to communicate.

Customer Assistance Warranty

Introduction

Quick Start
1.  Press and hold the Power button 

to turn 

on your radio.

2.  Press the Channel Up or Channel Down 

button to select a channel.

Both radios must be tuned to the  

same channel/privacy code to 

communicate.

3.  Press and hold the Talk button while 

speaking into the microphone.

4.  When finished talking, release the Talk 

button and listen for a response.

LI 7300

CXR925_MANL.indd   2-3

7/15/09   5:12 PM