Kenwood TM-G707 Manual De Usuario
51
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
ASSIGNING SPECIAL KEY FUNCTIONS
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 20 (PF1) to No. 23 (PF4).
3 Press [OK], then turn the Tuning control to select the
desired function.
• As you turn the Tuning control clockwise the selection
changes as shown below:
User Setting
➞ Monitor ➞ Enter (U.S.A./ Canada only)
➞ Voice ➞ PWR switch (PF 1 only) ➞ 1750 Hz Tone
(TM-G707E only)
4 Press [OK] again to complete the setting and exit
Menu mode.
User Setting:
Selects the front panel key function you assigned
{page 50}.
Selects the front panel key function you assigned
{page 50}.
Monitor:
Makes the squelch open and allows you to monitor
activity on the current frequency. This function is useful
when adjusting the volume or when receiving weak
signals.
Makes the squelch open and allows you to monitor
activity on the current frequency. This function is useful
when adjusting the volume or when receiving weak
signals.
• Pressing the re-programmed Mic key switches Monitor ON
or OFF.
• Scan will not function if Monitor is ON (squelch open).
Enter (U.S.A./ Canada only):
Allows you to enter digits from the MC-53DM
microphone. Refer to “KEYPAD DIRECT ENTRY”
{page 54}.
Allows you to enter digits from the MC-53DM
microphone. Refer to “KEYPAD DIRECT ENTRY”
{page 54}.
Voice:
Activates or deactivates function that announces the
current frequency using beeps of different frequencies.
Press any key to stop the beeps.
Activates or deactivates function that announces the
current frequency using beeps of different frequencies.
Press any key to stop the beeps.
(POWER) switch:
Turns the transceiver ON or OFF. This function can be
assigned only to PF 1.
assigned only to PF 1.
1750 Hz Tone (TM-G707E only):
After releasing the re-programmed Mic key with Transmit
Hold ON, the transceiver remains in the transmit mode for
2 seconds; a 1750 Hz tone is not continuously transmitted
for 2 seconds. A 1750 Hz tone is continuously transmitted
only while the re-programmed Mic key is being held.
After releasing the re-programmed Mic key with Transmit
Hold ON, the transceiver remains in the transmit mode for
2 seconds; a 1750 Hz tone is not continuously transmitted
for 2 seconds. A 1750 Hz tone is continuously transmitted
only while the re-programmed Mic key is being held.
• You can also use Transmit Hold to continuously send a
1750 Hz tone for 2 seconds after releasing the
re-programmed Mic key. To activate this function, access
Menu No. 26 (T.HLD) and select ON.
re-programmed Mic key. To activate this function, access
Menu No. 26 (T.HLD) and select ON.