Pioneer PDP-5070 Guía Del Usuario

En

• Attach the fittings for right and left sides to the bottom 

right and left on the rear panel of the Plasma Display 
using the supplied screws.

• Attach the center fitting to the lower center on the rear 

panel of the Plasma Display using the two supplied 
screws.

• See page 24 for speaker mounting procedures when using 

the hung on wall unit.

• Be sure not to mount the speaker upside down.

➁ Then, tighten the 

screw in the screw 
hole right under the 
upper hole.

Speaker mounting fitting for the left side
(the fitting method is the same as the 
fitting for the right side.)

“L” is inscribed 
(“R” is inscribed on 
the fitting for the 
right side).

Speaker mounting screw 
(M5 x 10 mm)

➀ Tighten the screw in 

the upper screw hole 
first.

Speaker mounting fitting for center

➁ Then, tighten the screw 

in the oval-shaped 
screw hole.

➀ Tighten the screw in the 

round-shaped hole first.

Speaker mounting screw 
(M5 x 10 mm)

Front side of the 
speaker

The upper side of the speaker 
does not have a round corner.

The bottom side of the speaker has a round corner 
when viewed from the front side of the Plasma Display.

Insert the speaker mounting 
fittings into the grooves at the 
rear of the speaker.

• To avoid any damage to 

the speaker and/or table 
top stand from striking 
against each other, fit the 
speaker to the mounting 
fittings while confirming 
their locations. As you 
may easily strike the 
stand, use the protective 
sheet in which the 
speaker was wrapped 
between the speaker and 
stand.

• When the speaker 

mounting fittings do not 
fit the grooves at the rear 
of the speaker, adjust the 
insertion angle.

For illustrative purposes, the table 
top stand is not presented here.

Sheet

PDP6070HD.book  Page 22  Friday, May 19, 2006  5:01 PM