Planet Technology GT-906B15 Manual De Usuario

2.2.2 Chassis Installation and Rack Mounting

To install the Managed Media Converter in a 10-inch or 19-inch with standard rack, follow the instructions described
below.

Step 1

: Place your Managed Media Converter on a hard flat surface, with the front panel positioned towards your front

side.

Step 2

: Carefully slide in the module until it is fully and firmly fitted into the slot of the chassis.

Figure 2-5

: Insert a Managed Media Converter into an available slot

Step 3

: Attach a rack-mount bracket to each side of the Chassis with supplied screws attached to the package.

Step 4

: After the brackets are attached to the chassis, use suitable screws to securely attach the brackets to the rack, as

shown in

Figure 2-6

Step 5

: Precede with the steps 4 and steps 5 of session 2.2.1 Stand-alone Installation to connect the network cabling

and supply power to your Chassis.

Caution:

You must use the screws supplied with the mounting brackets. Damage caused to the parts by using
incorrect screws would invalidate your warranty.

-10-