Black Box IC026A-R2 Manual De Usuario
24
RS-232
↔IEEE 488 INTERFACE CONVERTER
3.7 Feature Selections
The functions of the remaining switches are dependent on the mode
selected. A brief description of each of these features follows. You should
refer to the listed sections for additional information.
selected. A brief description of each of these features follows. You should
refer to the listed sections for additional information.
3.7.1 C
ONTROLLER
F
EATURES
In the IEEE Controller (RS-232-to-IEEE 488 Converter) mode, SW1-7 is
used to determine whether the interface should, after sending the IEEE
bus terminators, address the attached bus device to talk. The factory default
is Talk-Back On Terminator enabled.
used to determine whether the interface should, after sending the IEEE
bus terminators, address the attached bus device to talk. The factory default
is Talk-Back On Terminator enabled.
SW2-2 selects whether the interface converter should address the attached bus
device to talk when the interface converter has nothing more to send to that
device. The factory default is Talk-Back On Timeout enabled.
device to talk when the interface converter has nothing more to send to that
device. The factory default is Talk-Back On Timeout enabled.
Refer to Chapter 4 for complete details on these features.
Figure 3-12. Switch SW1: Enabling or Disabling “Talk Back
on Terminator” in Controller Mode.
Figure 3-13. Switch SW2: Enabling or Disabling “Talk Back
on Timeout” in Controller Mode.
Switch
Side
View
DOT
1 2 3 4 5 6 7 8
OPEN
Talk-Back on
Timeout Disabled
1 2 3 4 5 6 7 8
OPEN
Talk-Back on
Timeout Enabled
Switch
Side
View
DOT
1 2 3 4 5 6 7 8
OPEN
Talk-Back on
Terminator Disabled
1 2 3 4 5 6 7 8
OPEN
Talk-Back on
Terminator Enabled