DataVideo DAC-100 Manual De Usuario
C. Diagrams of typical cable connections
Make sure your VCR or Analog source is connected to the front inputs of the DAC-100 (LED’s are
on the front of the DAC-100).
on the front of the DAC-100).
A 6-pin FireWire cable can be connected to the front or rear of the DAC-100. The opposite end
should be connected to your 1394/connector on your computer.
should be connected to your 1394/connector on your computer.
If you would like to monitor your video, a composite video cable can be used to connect a video
monitor. Connect a composite RCA cable from the rear of the DAC-100 and connect the opposite
end to the input of your monitor.
Note: S-video cables only carry a video signal, so you will need to connect your RCA audio cables
to the converter to capture sound.
monitor. Connect a composite RCA cable from the rear of the DAC-100 and connect the opposite
end to the input of your monitor.
Note: S-video cables only carry a video signal, so you will need to connect your RCA audio cables
to the converter to capture sound.