Barco E-3620 Manual De Usuario
Windows 2000 BarcoMed Nio software installation
Nio® medical display systems
45
Windows 2000 BarcoMed Nio software installation
Note: These instructions apply to both Windows
®
2000 and
Windows
®
XP.
Preparation
Prior to installing your B
ARCO
M
ED
N
IO
software the following
should be done.
1. Install the BarcoMed Nio display controller(s) in your system.
2. Connect the B
ARCO
M
ED
N
IO
display panel(s) to the
BarcoMed Nio display controller(s) and power supply(s).
3. Decide if you want to install the NioWatch Software in
addition to the driver.
4. Decide if you are going to install the BarcoMed Nio driver
with DualView enabled or disabled) (see Step “7.” on
page 50 for a description of DualView).
page 50 for a description of DualView).
5. Decide which Palette Mode you wish to use with the
BarcoMed Nio display controller. If you are uncertain, use the
default setting as this setting can be changed later using the
BarcoMed Driver Tab of the Windows Display Properties
control panel.
default setting as this setting can be changed later using the
BarcoMed Driver Tab of the Windows Display Properties
control panel.
6. Put the BarcoMed Nio 2MP display panel in landscape
position before installing the software. Put the BarcoMed Nio
3MP/5MP display panel in portrait position before installing
the software. If you wish to change the panel orientation
later, the image orientation will adapt automatically to the
panel orientation after rebooting the PC.
3MP/5MP display panel in portrait position before installing
the software. If you wish to change the panel orientation
later, the image orientation will adapt automatically to the
panel orientation after rebooting the PC.
Note: Both displays connected to a single display controller
must have the same physical orientation and resolution in
order to be attached to the Windows desktop.
must have the same physical orientation and resolution in
order to be attached to the Windows desktop.