Chief Manufacturing interface bracket Manual De Usuario
Installation Instructions
Model FSB-4101
3
NOTE: If the flat panel display has a table stand
attached, remove existing stand.
attached, remove existing stand.
Flush Mount Installation
1.
Secure the Interface Bracket to the Display using 1/8"
Nylon Spacers and M4 x 12mm screws
(see Figure 2).
Nylon Spacers and M4 x 12mm screws
(see Figure 2).
NOTE: Length of mounting screws is dependant
upon length of spacer used.
upon length of spacer used.
Figure 2:
Recessed Mount Installation
1.
Place four Nylon spacers (3/8" or 3/4" as necessary)
over four mounting holes in Display (see Figure 3).
over four mounting holes in Display (see Figure 3).
2.
Secure the Interface Bracket to the Display using M4
x 20mm or M4 x 30mm screws depending upon
spacer used. (see Figure 3).
x 20mm or M4 x 30mm screws depending upon
spacer used. (see Figure 3).
Figure 3:
Mount to Q2 System
1.
Install flat panel display, with interface plate attached,
on Q2 mount (see Figure 4).
on Q2 mount (see Figure 4).
2.
Move latching flag of Q2 mount to secure display.
Figure 4:
Conversion to VESA 75mm Mounting/Centris®
Mounts
Mounts
1.
Remove Phillips head screws and mounting buttons
from the interface bracket.
from the interface bracket.
Figure 5:
2.
Using M4 x 6mm screws, attach the interface bracket
to any VESA 75mm x 75mm mounting device.
to any VESA 75mm x 75mm mounting device.
Display
Interface
Bracket
Bracket
1/8" Nylon Spacers (6)
M4 x 12mm Screws(6)
Display
Interface
Bracket
Bracket
3/8" or 3/4" Nylon Spacers(6)
M4 x 20mm Screws(6)
M4 x 30mm Screws(6)
M4 x 30mm Screws(6)
Display
Interface
Bracket
Bracket
Q2 Mount
Latching Flag
Display
Interface
Bracket
Bracket
Mounting Button
Phillips Head
Screw (4)
Screw (4)
VESA Mount