gohastings.com POWERPOD 400 Manuales de usuario

Tabla de contenidos

• POWER

  12
• COMMUNICATIONS

  12
• TRANSDUCER CONNECTIONS

  13
• ALARMS

  13
• ANALOG SIGNAL FOLLOWERS

  14
• POWER ON/OFF

  15
• CHANGING THE COMMAND SET POINT

  15
• OVERRIDE OPEN

  15
• OVERRIDE CLOSED

  15
• SETTING A CHANNEL TO AUTO CONTROL

  16
• SETTING A CHANNEL TO DIRECTLY METER INCOMING SIGNALS

  16
• SETTING A CHANNEL TO DISPLAY THE TOTALIZER FUNCTION

  16
• SELECTING EXTERNAL/REMOTE OPERATION (FRONT PANEL O NLY)

  18
• CHOOSING RS-232 COMMUNICATION

  18
• CHOOSING RS-485 COMMUNICATION

  18
• ENTERING THE SETUP/CAL MODE

  19
• DISPLAY SETUP

  19
• BLANKING A DISPLAY LINE/CHANNEL

  19
• SELECTING DISPLAY BRIGHTNESS

  19
• SELECTING UNIT -OF-MEASURE

  20
• SELECTING GAS ID

  20
• SETTING A/D CONVERSION RATE (FILTER)

  20
• FRONT PANEL LOCK OUT

  21
• TOTALIZER SETUP

  21
• COUNT UP TO A SET POINT

  21
• COUNT DOWN FROM A SET POINT

  22
• COUNT CONTINUOUSLY

  22
• EXTERNAL COMMUNICATION SETUP

  22
• RS-232 SETTINGS

  22
• RS-485 SETTINGS

  22
• SELECTING THE ANALOG SIGNAL LEVEL

  23
• ZERO TO FIVE VOLT O PERATION

  23
• 10.5.2. ZERO TO TEN VOLT OPERATION

  23
• SETTING LIMIT ALARMS

  24
• 10.6.2. SETTING A SINGLE CHANNEL ’S LOW LIMIT

  24
• SETTING RATIO CONTROL PARAMETERS

  25
• CALIBRATING A CHANNEL TO ITS INCOMING SIGNALS

  26
• 10.8.2. RESETTING THE SPAN O NLY

  26
• 10.8.4. SETTING A MULTIPLICATION FACTOR

  27
• SERIAL COMMUNICATION

  28
• 10.9.2. SET POINT Q UERIES

  28
• WARRANTY REPAIR POLICY

  42
• NON-WARRANTY REPAIR POLICY

  42