Manual De UsuarioTabla de contenidosTable of contents31 Copyright, Safety and Warranty51.1 Copyright information51.2 Important safety notes61.3 Safety precautions71.4 FCC/IC information72 System Overview83 Mounting the device93.1 Indoor installation93.1.1 Spacing93.1.2 Mounting height93.1.3 Multi-floor installations93.2 Outdoor installation103.2.1 Spacing103.2.2 Mounting height103.2.3 Overhangs/eaves103.3 Pre-wired installations103.4 Drilling templates113.4.1 Drilling template for outdoor enclosure bottom entry123.4.2 Drilling template for outdoor enclosure rear entry134 Layout and Wiring of the Device144.1 Layout of the coordinator/receiver154.1.1 Layout of the coordinator154.1.2 Layout of the receiver164.2 Wiring guidelines174.3 Power supply connector174.4 Power over Ethernet (PoE) connector174.5 RS-485 communication connector184.6 RS-485 jumpers184.7 Input connectors184.8 Output connectors194.9 LED indicators204.10 Tamper switch204.11 Reset button215 Setting the Switches and Jumpers225.1 Setting the loop address235.2 Selecting the hard/soft reset mode235.3 Setting the baud rate245.4 Enable/disable the buzzer245.5 Enable/disable the spacing mode245.6 Setting the jumpers for RS-485 communication loop256 Troubleshooting the Device276.1 Checking the power supply276.2 Checking Power over Ethernet (PoE)276.3 Checking the RS-485 communication276.4 Resetting the coordinator/receiver276.5 Upgrading coordinator/receiver firmware286.6 Checking address conflicts287 Appendices297.1 Differences between hard and soft reset mode on the coordinator/receiver29Blank Page31Tamaño: 3 MBPáginas: 32Language: EnglishManuales abiertas