Manual De UsuarioTabla de contenidosDialog Telephone Interface Module1Product Summary1Tools and Supplies Needed1Installation1Installation Guidelines1Programming-Adding the DTIM to Panel Memory21. Remove the DTIM cover and install the antennas (see Figure 1).2Figure 1. Antenna Installation22. With the system disarmed, enter program mode at the Allegro panel by pressing 8 + CODE.23. Press twice and É twice. The Allegro display shows zone 01 - trip.24. Locate the DTIM tamper switch and LED (see Figure 2 at left).25. Press and release the DTIM tamper switch as follows:26. Exit from program mode.2Testing DTIM Transmitting Range21. Place the DTIM in the desired location.22. Put the Allegro panel into sensor test mode. The panel piezo should sound 7 - 8 beeps. This indicates good reception from the DTIM to the panel.23. If you hear fewer than 7 beeps, test the DTIM in different locations. Mounting locations should be limited to areas where the panel responds with 7 - 8 beeps.24. To retest transmitting range after relocating the DTIM, press Ç then É at the Allegro panel and listen for 7 - 8 beeps.25. Exit from test mode after determining acceptable locations.2Mounting31. With the cover off, place the DTIM at the desired location and mark the mounting holes (see Figure 3 at left).32. Make holes in the wall for anchors at the marked locations.33. Insert wall anchors where necessary, then use two #6 screws to secure the DTIM to the wall.3Wiring a Phone Line to the Module31. Run a 4-conductor cable from the TELCO block to the RJ-31X (A in Figure 4).32. Connect the 4-conductor cable wires to the RJ-31X (B in Figure 4).33. Disconnect the Green and Red premises phone jack wires from the TELCO block and splice them to the 4-conductor cable Black and White (or Yellow) wires (C in Figure 4). Use weath erproof wire connectors for these splices.34. Connect the 4-conductor cable Green and Red wires to the TELCO block TIP (+) and Red to RING (-) posts (D in Figure 4).35. Insert the 8-conductor phone cord plug into the RJ-31X jack (E in Figure 4).36. Remove the right knockout on the DTIM plastic, feed the 4-conductor phone cord plug through it and connect the plug into the DTIM phone jack (Figure 5 at right).3Phone Test31. Call the central monitoring station to inform them you are testing the system.32. Make sure the panel has the correct account number and central station receiver phone num ber programmed.33. Enter the appropriate phone test command for the panel used in the system.34. Contact the central monitoring station when you are finished testing.3Installing the Battery Ty-wrap and Cover Screw (UL Listed Installations Only)3Trouble- shooting4No Dial Tone4Constant Dial Tone4No System Response4Trouble Condition4Module Supervisory4Specifications4Notices5Document Number: 466-1849 Rev. B October 2002 PRELIMINARY1Preliminary 10/4/021Tamaño: 600 KBPáginas: 8Language: EnglishManuales abiertas
