Star Trac S-RB Manuel D’Utilisation

 

 

7 

The Star Trac Universal PVS Kit is different for each of your Star Trac E or S Series Cardio products.  Make sure you have the 
proper kit for the E or S Series product you are installing. The E- & S -UB, E- & S-RB, E- & S-TBT, and E- & S-ST will follow 
the same basic steps for installation.  
 

To install the TV neck on the E-UB, E-RB, and E-TBT, and follow these steps: 
 

 

 

 

 

 

STEP1 
 
Using a #2 Phillips screwdriver, to  remove the (8) 
screws on the back of the display plastic.  Set the  
screws aside, you will need them for reassembly. 

STEP2 
 
After the screws have been removed, carefully  open 
the display plastic, so as to not detach the  inner 
cables from the display. 

Disconnect the ground wire   

   between the 

Heart  Rate board and the display mount. 

STEP3 

Disconnect the 12-pin serial connector 

and the 

Heart Rate cable from the

 display.  

After all the cable/harnessing has been 
disconnected, place the front display plastics 
aside for later use. Be careful with the display and 
place it face down on top of a non-scratching 
surface.