Yamaha RX-A1030BL Manuel D’Utilisation

PREPARATIONS

➤ Connecting speakers

En

■

Under its default settings, the unit is configured for 8-ohm speakers. When connecting 
6-ohm speakers, set the speaker impedance to “6 

 MIN”. In this case, you can also 

use 4-ohm speakers as the front speakers.

While holding down STRAIGHT on the front panel, press 
MAIN ZONE z.

 MIN”.

Press MAIN ZONE z to set the unit to standby mode and remove the 
power cable from the AC wall outlet.

You are now ready to connect the speakers.

■

Connect the speakers placed in your room to the unit. 

If you have seven speakers, use two of them as surround back speakers (*1) or front 
presence speakers (*2).

If you have five speakers, use two of them as surround speakers (*3) or front presence 
speakers (*4).

• You can also connect up to 2 subwoofers (with built-in amplifier) to the unit.

• To use an external power amplifier (Hi-Fi amplifier, etc.) to enhance speaker output, see “Connecting an 

external power amplifier” (p.24).

MAIN ZONE z

STRAIGHT

SPIMP.-

         8  M I N

 S P E A K E R  I M P .

• Remove the unit’s power cable from an AC wall outlet and turn off the subwoofer before connecting the 

speakers.

• Ensure that the core wires of the speaker cable do not touch one another or come into contact with the 

unit’s metal parts. Doing so may damage the unit or the speakers. If the speaker cables short circuit, 
“Check SP Wires” will appear on the front display when the unit is turned on.

Main zone

Front (L)

1

●

●

●

●

Basic (default)

Front (R)

2

●

●

●

●

Center 

3

●

●

●

Surround (L)

4

●

●

*3

Surround (R)

5

●

●

*3

Surround 
back (L)

6

●

*1

Surround 
back (R)

7

●

*1

Front 
presence (L)

E

●

*2

*4

Front 
presence (R)

R

●

*2

*4