Impex PWR 6 Manuel D’Utilisation

STEP 9 (See Diagram 9 & Cable Loop Diagram) 
A.) Attach the 100” Upper Cable (#68) to the opening on the front Upper Frame (#55). Make 

sure the ball stopper of the Cable is under the Frame. 

B.) Attach a Pulley (#70) to the opening. Secure it with one M10 x 2 ½” Allen Bolt (#85), two 5/8” 

Pulley Bushings (#79), and one M10 Aircraft Nut (#44).  

C.) Draw the Cable along the Upper Frame towards the back of the machine to the opening on 

the Upper Frame.  Repeat Step B above to install a Pulley. 

D.) Draw the Cable around the Pulley and downward. Attach a Pulley to the Double Floating 

Pulley Bracket (#62). Secure it with one M10 x 1 ¾” Allen Bolt (#86), two 

∅

 ¾” Washers 

(#42), and one M10 Aircraft Nut (#44). Let the Bracket hanging for now.   

E.) Draw the Cable around the Pulley and up to the opening on the top of the Rear Vertical 

Frame (#52). Attach a Pulley to the opening. Secure it with one M10 x 2 3/8” Allen Bolt (#87), 
two ½” Pulley Bushings (#78), and one M10 Aircraft Nut (#44). 

F.) Draw the Cable down to the Sliding Weight Post (#56).  Secure the end of the Cable with 

one M10 x ¾” Allen Bolt (#36), two 

∅

 ¾” Washers (#42) and one M10 Aircraft Nut (#44).