Impex IGS-8862 Manuel D’Utilisation
ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches.
NOTE: It is strongly recommended that two or more people assemble this machine to
avoid possible injury.
STEP 1 (See Diagram 1)
A.) Do not tighten the Nuts and Bolts until instructed to do so.
B.) Attach the Left Diagonal Support (#3) to an Upright Beam (#1). Secure the top & bottom to
Wrenches.
NOTE: It is strongly recommended that two or more people assemble this machine to
avoid possible injury.
STEP 1 (See Diagram 1)
A.) Do not tighten the Nuts and Bolts until instructed to do so.
B.) Attach the Left Diagonal Support (#3) to an Upright Beam (#1). Secure the top & bottom to
the Upright with four M10 x ¾” Allen Bolts (#51) and four Ø ¾” Washers (#54). Repeat the
same procedure to install the Right Diagonal Support (#4) to another Upright Beam.
same procedure to install the Right Diagonal Support (#4) to another Upright Beam.
C.) Connect the Left & Right Diagonal Support (#3) & (#4) with a Cross Brace (#2) in the mid-
span. Secure each end with two M10 x 2 ¾” Carriage Bolts (#46), one 5 ½” x 2” Bracket
(#27), two Ø ¾” Washers (#54), and two M10 Aircraft Nuts (#56).
(#27), two Ø ¾” Washers (#54), and two M10 Aircraft Nuts (#56).
D.) Securely tighten all Nuts and Bolts installed.
E.) Insert two Weight Posts (#7) into the Left & Right Diagonal Support. Secure each Weight
E.) Insert two Weight Posts (#7) into the Left & Right Diagonal Support. Secure each Weight
Post with one M10 x ¾” Allen Bolt (#51) and one Ø ¾” Washer (#54). Slide an Olympic
Sleeve (#43) onto each Weight Post. Attach a Spring Clip (#29) onto each Sleeve.
Sleeve (#43) onto each Weight Post. Attach a Spring Clip (#29) onto each Sleeve.
F.) Attach the two Safety Catches (#5) onto the Upright Beams, and then attach the two Bar
Catches (#6) onto the Upright Beams. Use a 3 5/8” Long Pin (#21) to lock each Safety
Catch and Bar Catch at selected position.
Catch and Bar Catch at selected position.
5