NordicTrack NTEX4196.0 Manuel D’Utilisation

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing

materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included tools and your own adjustable wrench and Phillips screw-

driver .

Use the part drawings below to identify the small parts used in assembly. The number in parentheses below

each drawing is the key number of the part, from the PART LIST on page 21. The number following the paren-

theses is the quantity needed for assembly. Note: Some small parts may have been pre-attached. If a part is

not in the parts bag, check to see if it has been preattached.

M8 Nylon

Locknut (60)–4

M8 x 19mm Button

Screw (77)–4

M8 x 16mm Button

Screw (54)–6

M8 Split

Washer (55)–14

M4 x 16mm

Round Head

Screw (80)–6

M6 Washer

(75)–4

M10 x 63mm Bolt

Set (62)–1

M8 x 41mm Button

Bolt (45)–4

M8 x 50mm Button

Screw (52)–4

M6 x 16mm Button

Screw (81)–4

M6 x 30mm Button

Screw (37)–4

M4 x 12mm

Screw (25)–1

1. Orient the Left Front Stabilizer (15) with the Wheel (17)

in the position shown. Attach the Left Front Stabilizer

to the left side of the Frame (1) with three M8 x 16mm

Button Screws (54) and three M8 Split Washers (55).

Attach the Right Front Stabilizer (not shown) to the

right side of the Frame (1) in the same way.

ASSEMBLY