Emerson MMI-20011276 Manuel D’Utilisation

23

This chapter explains how to configure the NOC application and perform density determination 
procedures.

The following topics are discussed:

•

Basic configuration procedure – see Section 4.3

•

Setting up a water cut monitor – see Section 4.4

•

Setting up pressure compensation – see Section 4.5

•

Setting up Transient Bubble Remediation – see Section 4.6

•

Setting up gas measurement – see Section 4.7

•

Setting up Transient Mist Remediation – see Section 4.8

•

Performing density determination procedures – see Section 4.9

-

Density determination for water – see Section 4.9.1

-

Density determination for oil – see Section 4.9.2

Failure to perform configuration tasks in the proper sequence could result in an incomplete 
configuration. See Section 1.3 for the recommended configuration sequence.

Use the Well Performance Measurement menu, shown in Figure 4-1, to access and configure NOC 
parameters. The Well Performance Measurement menu is accessed through the Configuration option 
of the Management menu. To access the Management menu, see Chapter 3.

To ensure accurate NOC data, follow the instructions in Section 5.2.4 (Well Test mode) or Section 5.3.4