ResMed AUTO 25 Manuel D’Utilisation
3
Using the VPAP Auto 25, VPAP ST & VPAP S
En
gli
sh
Supplemental Oxygen
The VPAP Auto 25, VPAP ST and VPAP S are designed to be compatible with the
following levels of supplemental oxygen usage:
following levels of supplemental oxygen usage:
•
Up to 4 L/min in VAuto mode
•
Up to 15 L/min in CPAP, S, ST and T modes.
At a fixed flow rate of supplemental oxygen flow, the inhaled oxygen concentration
will vary, depending on the pressure settings, patient breathing pattern, mask
selection, and the leak rate.
will vary, depending on the pressure settings, patient breathing pattern, mask
selection, and the leak rate.
!
WARNING
Always use the ResMed Oxygen Connector Port when adding supplemental
oxygen at the flow generator outlet.
oxygen at the flow generator outlet.
Using the VPAP Auto 25, VPAP ST & VPAP S
Setting up your VPAP
1
Connect the power cord to the socket at the rear of your VPAP.
2
Plug the other end of the power cord into the power outlet.
3
Connect one end of the air tubing firmly onto the air outlet.
4
Connect the assembled mask system to the free end of air tubing.
For information on assembling your mask, see your mask manual.
For information on assembling your mask, see your mask manual.
!
WARNING
•
Make sure the power cord and plug are in good condition and the
equipment is not damaged.
equipment is not damaged.
•
Only ResMed air tubing should be used with the device. A different type of
air tubing may alter the pressure you actually receive, reducing the
effectiveness of your treatment.
air tubing may alter the pressure you actually receive, reducing the
effectiveness of your treatment.
•
Blocking the hose and/or air inlet of the device while in operation could lead
to overheating of the device.
to overheating of the device.
1
2
3
4