ResMed Stellar 150 Manuel D’Utilisation

17

Setup menu

En

glis

h

Learn Circuit 

The device is calibrated according to your air tubing system.  
1. If in use, turn off the oxygen flow.
2. Select the mask type.
3. Set up the air circuit including accessories and patient interface.

Note: For invasive use, do not connect a catheter mount, 
tracheostomy tube or HMEF, see “Setting up for invasive use” 
on page 5).

4. Leave the air circuit unobstructed and open to the air.
5. Press 

 to start the Learn Circuit.

6. Wait for the device to complete its automated tests (<30 sec).

 

The results are displayed when complete. If the circuit 
configuration has been successfully learnt, 

 displays. If 

unsuccessful, 

 displays (see “Troubleshooting” on page 22).

FiO

2

 Sensor 

Calibration

The device starts the calibration of the FiO

2

 monitoring sensor to 

measure the oxygen concentration of the breathable air. 
1. Press 

 to start the FiO

2

 sensor calibration. 

2. Wait for the device to complete its calibration.

The results are displayed when complete.

Ramp Time

If Max Ramp Time has been set by the clinician, you may select any 
value up to this time. 
Options: 0 min-Max Ramp Time (max 45 minutes, 5 minutes 
increments)

Language

Sets the display language. 
Options: Depending on regional configuration

Brightness

Sets the LCD backlight brightness.
Options: 20-100%, 10% increments

Backlight

Enables the LCD and keypad backlight. 
If the AUTO setting is selected the backlight turns dark after five 
minutes without any actions and turns on again if any button is 
pressed again or an alarm occurs.
Options: On, Auto

Time format

Sets the time format.
Options: 24 hrs,12 hrs

Date format

Sets the date format.
Options: dd/mm/yyyy, mm/dd/yyyy

To return to the Options screen press the Return button