GE 20622 Manuel D’Utilisation

8

The Auto Code Search searches automatically 
through all of the codes stored in this remote. Read 
all the following steps prior to starting the auto 
search as you will need to be prepared to lock-in the 
proper code when found. 

1.  Manually turn on the device you wish 

to control.

2.  Press and hold the 

SETUP button until 

the red indicator light stays on 
(approximately 4 seconds) and then 
release the button. 

3.  Press and release the desired device 

button on the remote (

SAT, DVR/AUX). The red indicator will 
blink once and then remain on. 

4.  Point the remote at the device and 

press and release the 

POWER button 

(for TV) or 

PLAY button (for DVD, VCR, 

etc.) to start the search. The red 
indicator will flash (approximately 
every 2 seconds) as the remote 
searches. 

5.  Place your finger on the 

#1 button so 

you are prepared to lock-in the code.

6.  When the device shuts off or begins 

playing, press the 

#1 button to 

lock-in the code.  The red indicator 
light will turn off. 

approximately two seconds after the 
device shuts off or begins playing to 
lock-in the code. 

7.  Point the remote at the device and 

check to see if the remote operates the 
device as desired. If it does, no further 
programming is required for that 
device. If it does not, return to step 2 
and start the auto search again.