Philips SRP5004/86 Manuel D’Utilisation

English

3.2 Learning button functions

If you miss certain functions from your original remote

control on the SRP5004, the SRP5004 can learn these

functions. You can store a function under any of the

available buttons, except under the device selection buttons

(

) and the

button. Any function already

stored under a button will be deleted.

The SRP5004 is equipped with two dedicated buttons for

learning additional functions: and . These buttons do

not have a default function and enable you to add extra

button functions without deleting any SRP5004 functionality.

Make sure that you have the original remote control at

hand.

Select the desired device

(e.g. DVD). Press the

device selection button to

select DVD.

• The button lights up.

Place both remote controls

on a flat surface (like a

table) and aim them

head-to-head with about 5

- 10 cm in between.

Keep the

button and

the button you wish to

learn on the SRP5004 (e.g.

the

button) pressed

simultaneously for 5 seconds,

until the red Setup LED

lights up.

• The remote control is now in learn mode.

Press and hold the button that you wish to learn on the

original remote control until the

device selection

button gives two short blinks and both button and Setup

LED go out to confirm that learning was successful.

• The remote control has now learned the new

function.

Note

• It may occur that learning a button function fails the

first time. The device selection button will then give a

long blink and both button and Setup LED will go

out. In this case, please try again.

• If you keep having trouble learning button functions,

check the batteries in both SRP5004 and original

remote control and replace if necessary.

• It may also be that the remote control learn memory

is full (a total of 60 buttons can be learned). In this

case you can reset one or more buttons to their all

original functions in order to create memory space.

For this, see chapter 3.3.

3.3 Resetting a button to its original function

If an improved button (see chapter 2.2.2) still does not

function as expected, you can always reset the button to

its original function. When resetting a button to its original

function, any learned function stored under the button will

be deleted.

In the current device

mode, keep digit buttons

and pressed

simultaneously for 5 seconds,

until the red Setup LED

lights up.

• The remote control is now in setup mode.

Press digit buttons , ,

and , in that order.

• After each button press

the device selection

button blinks once.

Press the button you wish

to reset twice. E.g. the 22

button.

• After each button press

the device selection

button blinks once.

• The device selection button will blink one more time

to confirm that the button was succesfully reset to its

original function.

• The button can now also learn a new function, if

desired.

Using

the

univ

ersal

remote

contr

5 sec.

2 x