Patton electronic 07MSMARTMEDIA-SCG Manuel D’Utilisation

Configuring an M2PA System

Smart Media Software Configuration Guide 

Line interface is a generic term for TDM physical interfaces. The SmartNode 10200 Series supports three types 
of physical interfaces: T1/E1/J1 interfaces, DS3 interfaces, and Oc3/STM1 interfaces.

To create a new line interface:

1. Select Tdm Interfaces-->Line Interfaces from the navigation panel:

Figure 162. TDM Interfaces > Line Interfaces

2. Click Create New Line Interface to create a single interface, or Create Multiple Line Interfaces to create 

many interfaces at once:

Figure 163. Line Interface List

3. Create the new line interface:

– Enter  a  name for the interface

– Set  a  type for the interface

Table 28. Configuration Parameters for New Hardware Adapters

Used by the Web Portal to indicate a specific object or string in the system

Defines a product serial number, when creating a new hardware device. Enter-
ing characters into the Serial field will cause the number to auto-complete.

Specifies the type of hardware device being created, when adding a new 
adapter. Possible values: TMP/TMS

Sets a maximal delay for calls to terminate normally before an adapter is 
upgraded

Identifies the physical location of a hardware adapter

Describes the purpose of a particular hardware adapter

Sets the live state of a hardware adapter. Possible values: 
Disabled/Probation/Enabled