Universal Remote Control URC-WR7 Manuel D’Utilisation
Page 30
Erasing Commands -
Overview
You can erase a single learned command, all
learned commands in each component mode,
SimpleSound programming, MacroPower com-
mands, or re--set the remote to original factory
default settings.
learned commands in each component mode,
SimpleSound programming, MacroPower com-
mands, or re--set the remote to original factory
default settings.
Erasing a Single Learned Command from
One Component
One Component
STEP 1:
Press the component button where
the learned command is stored and the [ENTER]
button at the same time for two seconds until the
component LED light turns on.
button at the same time for two seconds until the
component LED light turns on.
IMPORTANT:
You have 30 seconds to per-
form the next step while you are in programming
mode. If you do not press a button within 30 sec-
onds, the component LED light will turn off. The
remote will exit the programming mode and you
will have to start over.
mode. If you do not press a button within 30 sec-
onds, the component LED light will turn off. The
remote will exit the programming mode and you
will have to start over.
STEP 2:
Press and hold the button you
want to erase for two seconds. The compo-
nent LED light will blink twice to confirm the
erasure.
nent LED light will blink twice to confirm the
erasure.
STEP 3:
Repeat Step 2 to erase any other
buttons in the selected component mode.
STEP 4:
To exit Erase mode, press and
hold both the component button and the
[ENTER] button at the same time until the
component LED light blinks three times.
[ENTER] button at the same time until the
component LED light blinks three times.
COMPONENT
BUTTONS
ENTER