VIZIO XRU110 Manuel D’Utilisation

VIZIO

Insert the battery to the battery

compartment to activate the remote control.

Precautionary Tips for Inserting the Battery

• Only use AAA batteries

• Inserting the battery incorrectly may result in

cracking or leakage that may pose a ﬁ re risk or

lead to personal injury.

• Dispose of the battery in accordance with local

laws and regulations.

• Keep the battery away from children and pets.

Battery Saver

Your remote automatically turns off if the buttons

are depressed more than 30 seconds.

Code Saver

You will have up to 10 minutes to change the

battery in your remote without losing codes you

have programmed. However, to avoid losing your

codes, do not press any buttons until battery is

installed in the remote.

Battery replacement

Insert two AAA

batteries into the remote

control. Make sure that

you match the (+) and (-)

symbols on the battery

with the (+) and (-)

symbols inside the battery

compartment. Re-attach

the battery cover.

Searching for Component Codes

If you cannot find the manufacturer in the compo-

nent list or the program code does not work, you

can use the remote control to search for the correct

component code.

To search for a component code:

1. Manually turn on the component.

2. Press the matching component (TV, STB or

DVD) button and hold for 5 seconds until the

LED flashes twice. LED will remain lit.

3. Press 9 9 1 using the Number Buttons. The

LED flashes twice after the last digit is entered

and LED will remain lit.

4. Point the remote control at the component and

then press the POWER button to start code

search. LED will flashes every 3 second during

the search. Move your finger to the OK button.

6. After the component turns off, press the OK

button within three seconds to save the code.

If the component does not respond correctly,

repeat the search procedure to find another

code.

Reset Remote to Factory Settings:

1. Press and hold V button for 5 seconds until the

LED flashes twice. LED will remain lit.

2. Press 9 1 9 1 9 using the Number Buttons. The

LED flashes twice after the last digit is entered

and then turns off. The remote is now reset to

factory settings.

p

u

t

e

S

p, cont.

u

t

e

S

p

u

t

e

S

l

a

it

i

n

I

Programming for TV, STB or DVD

Note: TV mode can be programmed for TV

codes ONLY. STB and DVD mode can be

programmed to control ANY kind of device

listed in the code list. The remote is

pre-programmed to operate VIZIO TVs under TV

mode and VIZIO Blu-Ray Players under DVD

mode.

1. Manually turn on your TV (STB or DVD).

2. Press the TV (STB or DVD) button and hold for

5 seconds until the LED flashes twice. LED will

remain lit.

3. Find the programming code for your TV (STB or

DVD) in the code list and enter it using the

Number Buttons. The LED flashes once after

entering each digit. If the code is accepted,

the LED flashes twice after the last digit is

and then turns off.

If the code is invalid, the LED will have a long blink

and then turns off. Please repeat Steps 2 and 3

with the next code listed for the component and

manufacturer.

4. Point the remote control at the TV (STB or

DVD) and press the POWER button. The TV

(STB or DVD) should turn off.

Note:

• If your TV (STB or DVD) does not respond, try

all the codes for your brand. If the codes do not

work, or your brand is not listed, see “Searching

for Component Codes, page 13.”

• Sometimes a code listed will only include limited

functions. Try other codes that may include

more functionality.

5

6

7

8