Invacare 1500 Manuel D’Utilisation
OPERATING THE BATH LIFT
15
FIGURE 2.7 Disinfecting the Lift
Mounting the Battery Charger
NOTE: For this procedure, refer to FIGURE 2.8.NOTE: Refer to state and local regulations concerning proper mounting procedures.
1. Place the battery charger mounting bracket on the wall at the desired position.
2. With a pencil, mark the mounting hole positions.
3. Install the mounting screws (not shown) until there is an approximate 1/8‐inch gap
between the screw head and the wall.
4. Install the battery charger with mounting bracket onto the mounting screws.
5. Tighten the mounting screws (not shown) securely.
6. Plug the battery charger power cord into the wall electrical outlet.
NOTE: The RED and GREEN LEDs will illuminate. The illumination of the LEDs indicates that
the charger is operable.
the charger is operable.
DETAIL “A” - NON ELECTRONIC SURFACES
Stretcher
Surface
Base
DETAIL “B” - ELECTRONIC SURFACES
Push
Handle
Hand
Pendant
NOTE: Safety straps not shown.
Scale
Arm Rests
Seat
Surface
Base
Push
Handle
Hand
Pendant
Scale