Invacare 1150703 Manuel D’Utilisation
SECTION 2—ASSEMBLY
10
SECTION 2—ASSEMBLY
Assembling the Patient Lift
Assembling the Mast Assembly to the Base
NOTE: The mast assembly may be removed from the base for
storage or transporting. The mast assembly MUST be properly
secured to the base assembly before use.
NOTE: For this procedure, refer to FIGURE 2.1.
1.
storage or transporting. The mast assembly MUST be properly
secured to the base assembly before use.
NOTE: For this procedure, refer to FIGURE 2.1.
1.
Put the base on a level surface so all casters make
contact with the floor.
contact with the floor.
2.
Lock the rear casters (Detail “A”).
3.
Unscrew the top knob and remove it from the base.
4.
Loosen the bottom knob, but leave it screwed into the
base.
base.
5.
Connect the mast assembly cable (not shown) to the
base cable (not shown).
base cable (not shown).
6.
Put the tube of the mast assembly into the hole in the
base.
base.
7.
While supporting the mast assembly, tighten the
bottom plastic knob.
bottom plastic knob.
8.
Screw the top plastic knob into the hole in the base.
Assembling the Knee Pad to the Mast
Assembly
NOTE: For this procedure, refer to FIGURE 2.2.
NOTE: The knee pad may be removed from the patient lift for
storage or transporting. The knee pad MUST be properly secured
to the mast assembly before use.
1.
NOTE: The knee pad may be removed from the patient lift for
storage or transporting. The knee pad MUST be properly secured
to the mast assembly before use.
1.
Push the knee pad down into position on the knee pad
mounting bracket on the mast assembly.
mounting bracket on the mast assembly.
2.
Put the fix block in place on the knee pad mounting
bracket.
bracket.
3.
Insert the quick release knob through the mounting
bracket, kneed pad and fix block.
bracket, kneed pad and fix block.
4.
Tighten the quick release knob.
Assembling the Foot Plate to the Mast Assembly
NOTE: For this procedure, refer to FIGURE 2.3.
1.
1.
Rotate the foot plate up and place the hooks on the foot
plate onto the top mounting bolts in the mast assembly.
plate onto the top mounting bolts in the mast assembly.
2.
Rotate the foot plate down towards the mast assembly.
The bottom of the foot plate will rest against the bottom
bolts on the mast assembly.
The bottom of the foot plate will rest against the bottom
bolts on the mast assembly.
3.
Ensure that the foot plate is level and secure.
FIGURE 2.1 Assembling the Mast Assembly to the Base
FIGURE 2.2 Assembling the Knee Pad to the Mast Assembly
Top Knob
Base
Bottom Knob
DETAIL “A”
Push tab down
to LOCK.
Push tab UP
to UNLOCK.
Caster
Mast Assembly
Knee Pad
Knee Pad
Mounting Bracket
Quick Release
Knob
Fix Block
Foot Rest
(shown in place)
Top Mounting
Bolt
Bottom Mounting Bolt
Mast Assembly