Anritsu MG3641A Manuel D’Utilisation
SECTION 1 GENERAL
1-11
<Option>
■ Option 01 (Reference crystal oscillator)
● Frequency
● Frequency
10MHz
● Aging rate
5
×10
-10
/day
● Temperature characteristics
±5×10
-9
(0 to 50
°C)
■ Option 11 (Pulse modulator)
● Frequency
● Frequency
0.125 to 2080MHz
● On/Off ratio
>80dB
● Rise/Fall time
<100ns
● Min. pulse width
<500ns
● Pulse repetition frequency
DC to 1MHz
● Max. delay time
<100ns
● Overshoot/ringing
<20%
● Video feed through
<20%
● Pulse modulation signal
External, rear-panel BNC connector, 50/600
Ω, TTL (positive logic)
■ Option 21 (AF synthesizer)
● Frequency
● Frequency
0.01Hz to 400kHz (sine wave)
0.01Hz to 50kHz (triangular wave, square wave, sawtooth wave)
0.01Hz to 50kHz (triangular wave, square wave, sawtooth wave)
● Resolution
0.01Hz
● Waveform
Sine, triangular, square, sawtooth
● Frequency accuracy
Same as reference oscillator
■
Option 22 (FSK encoder)
● Frequency shift amount: Shifts frequency depending on data state, as below.
(Data2
1
, Data2
0
)=(0, 0): -FM deviation set value
(Data2
1
, Data2
0
)=(0, 1): -FM deviation set value/3
(Data2
1
, Data2
0
)=(1, 0): +FM deviation set value
(Data2
1
, Data2
0
)=(1, 1): +FM deviation set value/3
● Setting frequency: Set frequency for data input in the following timing.
Free: Shift frequency at data input.
Rise Trig: Shift frequency at rising edge of external clock.
Fall Trig: Shift frequency at falling edge of external clock.
Rise Trig: Shift frequency at rising edge of external clock.
Fall Trig: Shift frequency at falling edge of external clock.
● Baseband filter: Following filters can be used to pass signal.
Filter type: 10th-order Besser filter
Cutoff frequency: 100Hz to 30kHz(-3dB)
Set resolution: Upper 2 digits
Cutoff frequency: 100Hz to 30kHz(-3dB)
Set resolution: Upper 2 digits
● FM deviation accuracy: Same as that of MG3641A/MG3642A, with restriction of no baseband filter (by-passed)
● External modulation signal input
● External modulation signal input
Data2
0
: Rear-panel BNC connector (Int Mod Cont 2)
TTL level, pull-down
Data2
1
: Rear-panel BNC connector (Int Mod Cont 1)
TTL level, pull-down
● External clock signal input
Ext Clock: Rear-panel BNC connector (Int Mod Cont 3)
TTL level, pull-up