Genesis Advanced Technologies G2.2 Manuel D’Utilisation

a bs o l u t e f i d e l i t y

button, the display will flash

and then the current phase setting

will be shown. The next press of the button will move the phase up
or down.

Set the phase to zero as an initial setting. (If you are not driving the
servo-bass amplifier as recommended using the output of the
power amplifier, the phase will depend on the phase shift and
group delay of your power amplifier. A typical value will be 45 to
135 degrees.)

The high-pass (

) filter determines how low the woofers will play.

Set this initially to 24Hz until the woofers and amplifiers break in.
Then, it can be set to 18Hz. Next, adjust the low pass (

) filter

(how high the woofer goes). Set this to 95 using the button marked
"low pass" (on the remote control).

You will notice two controls on the back of the
midrange/tweeter panel. The left hand knob is
a trim control for the rear tweeters. Turning
this control clockwise will increase the level of
the rear tweeters.

If there is not enough space behind the G2,
the tweeter control can be turned down. In
large rooms, the tweeter control can be
turned up. Use this control if you need a bit
more treble or to increase the apparent space
of the soundstage. Start with this control at
the twelve o'clock position.

The control on the right side is a three-position switch used to
adjust the midrange. Start at position two. Position one will sound
fuller in the lower midrange while position three will sound leaner
and have more upper midrange.

The less obvious effect (more obvious to some people!!) of the
midrange control is to make the soundstage sound more forward,
and change the perceived height and position of the performance.
Relative to position two, you can raise the soundstage by moving to
position three (it’s like moving your seat forwards in the concert
hall!!)