Sony Ericsson P908 Mode D'Emploi

•

When the battery needs to be charged, a beep is heard. The 
indicator light (on the top of your P908) flashes red and a 
battery low message appears on the screen. 

•

The battery can be charged whenever you want. The P908 
performance is not affected. However, using your P908 while 
charging increases the charging time.

The P908 can be charged either when it is switched on or off.

1. Make sure the battery is inserted in your P908 and the cover 

is closed.

2. Connect the charger to 

the P908 at the base of 
the phone by the flash 
symbol. The charger 
plug flash symbol must 
face upwards.

3. Connect the charger to 

the mains.

Charging is indicated by the battery meter on the screen pulsing 
continuously, and the indicator at the top of the P908 showing a 
steady red light (or green, if the P908 is switched on).

See also ‘Battery Use and Care’ on page 183.

Tip You can also use other battery chargers that have been 
supplied with other Sony Ericsson mobile phones using the same 
connector plug, for example, T68i or T300.

Note When the battery is completely discharged, or new, it may 
take up to 30 minutes before the battery charging icon appears 
on the screen.

4. Wait approximately 4 hours or until the battery meter on the 

screen is full and the indicator on the top of the P908 shows a 
steady green light.

5. Remove the charger by tilting 

the plug upwards.

Your P908 is a highly sophisticated electronic device. To get the 
most out of it, please make sure that you follow this advice:

•

Keep the P908 in its protective bag when not using it. 

•

Use a commercial glass screen cleaner sprayed on a cloth, 
when you clean the screen.

•

Use only the stylus provided to tap the screen.