Bodyguard T280C Manuel D’Utilisation

If you experience a problem during the normal operation of the T280P – T280C – T320, use the following troubleshooting
table below. If you are unfamiliar or uncertain with basic diagnostic maintenance procedures, contact your Authorized
Bodyguard

®

Dealer for diagnostics or repair of your T280P – T280C – T320.

• Computer will not light

up when power
is turned ON.

• Belt doesn’t turn.

• Elevation does not

respond properly.

• Motor drive does not

respond properly.

• Motor turns backwards.

• Computer key(s) not

responding to touch, 
or sticking.

• Squeaking noise from

the motor.

• Belt tracks left 

and right.

• Speed is not constant or

seems too fast or slow.

• Can’t get out at the end

of a program.

• Error log

• Unit is not plugged in. – Plug unit in.

• Power cord. – Check that power cord is functional; replace if necessary.

• Circuit breaker. – Reset the breaker.

• Damaged motor circuit board. – Contact your Bodyguard

®

Dealer.

• The belt is over tensioned. – Perform Belt Alignment.

• The wires are not connected. – Remove the cover and connect the wires properly.

• Magnetic key is not in place. – Insert the magnetic key.

• It is not calibrated. – Perform Elevation Calibration.

• The wire is not connected on the motor circuit board. – 

Connect the elevation wire to the circuit board.

• It is not calibrated. – Perform Motor Check.

• The wire is not connected on the motor circuit board. – 

Motor wiring harness needs to be connected to the lower board.

• The wires are reversed on the circuit drive. – 

Contact your Bodyguard

®

Dealer.

• Keypad may be damaged by liquid penetrating through the seal. – 

Contact your Bodyguard

®

Dealer.

• Excessive amount of cleaning solution used. – 

Use mild cleanser on damp cloth only when cleaning console and unit.

• Poly V-belt slipping. – Contact your Bodyguard

®

Dealer.

• Motor brush noise excessive. – Contact your Bodyguard

®

Dealer.

• Uneven floor. – Move the treadmill to an even floor.

• Rear roller not adjusted for sloped floor. – 

The rear roller needs to be adjusted. Perform Belt Alignment.

• The drive motor is not calibrated. – Perform Motor Check.

• The tension on the motor drive is too excessive. – 

Remove tension on the running belt. Perform Belt Alignment.

• Elevation is not calibrated. – Perform Elevation Calibration.

• See table 4