Audiovox CDM-8500 Manuel D’Utilisation

Page de 74
CHARGING THE BA
CHARGING THE BA
TTER
TTER
Y
Y
NOTE:
Charging time applies only when your phone is
turned off. Charging time may vary if your phone
is turned on. 
NOTE:
These times are for a new battery. Talk and
standby time may decrease over time.
BATTERY TALK AND STANDBY TIMES
BATTERY CHARGING TIME
Chapter 1 - Page 15
CHARGING THE BA
CHARGING THE BA
TTER
TTER
Y
Y
NOTE:
1. It is more efficient to charge the battery with
the cell phone off.
2. The battery must be connected to the phone in
order to charge it.
3. If the LED flickers while charging. 
May need cleaning or there may be a problem 
with the battery.
4. Battery operating time gradually decreases over
time.
5. If the battery fails to perform normally, you may
need to replace the battery.
Page 14 - Chapter 1
The TRC-8500 rapid charger will both power the phone
and charge the battery simultaneously. The unit attach-
es directly to the phone. Charging time will vary depend-
ing on the battery’s initial capacity at the beginning of the
charge.
1. Attach the battery pack to the 
phone.
2. Insert plug into AC wall outlet.
3. Plug in the interface connector 
by gently inserting it into the 
appropriate contacts on the 
bottom of the phone.
4. LED will light RED during 
charging and turn to GREEN 
when the battery is fully charged.
5. The phone can be operated while the battery is 
charging.
6. To remove the TRC-8500 from 
your phone, press the release 
buttons on the sides of the 
interface connector and slide it 
away from the phone.
7. After recharging, the battery pack 
may become a little warmer. 
This is normal. 
NOTE: 1. 
The battery is not charged at the time of
purchase.
2. Fully charge the battery before use.
Battery Type
BTR - 8500
240 minutes
Charging Time
Standard Battery
(900mAh) 
190
90
150
12
Talk Time
(min)
Digital
Analog
Digital
Analog
Standby
Time 
(hrs)
50C-verginmobile3/21ºˆ¡§  2003.3.21  10:29 AM  Page 16