Roland AR-200 Manuel D’Utilisation
11
Installation
Rack-Mounting the AR-200
By attaching a rack mount adaptor to the AR-200 (RAD-50: sold separately) you can
install it in an EIA rack. One RAD-50 can accommodate up to two AR-200 units.
install it in an EIA rack. One RAD-50 can accommodate up to two AR-200 units.
1
Remove the four rubber feet from bottom of the unit.
fig.set-02
2
Attach the RAD-50 adaptor to the AR-200 using the screws
that are supplied with the RAD-50.
that are supplied with the RAD-50.
fig.set-03
Attaching the Card Protector
By attaching the Card Protector (supplied) to the AR-200, you can prevent the
PC card from inadvertently being removed from the AR-200.
After confirming that the card is securely inserted in the card slot, use the
provided screws to attach the Card Protector, as shown in the figure below.
PC card from inadvertently being removed from the AR-200.
After confirming that the card is securely inserted in the card slot, use the
provided screws to attach the Card Protector, as shown in the figure below.
fig.set-04
Note: Do not use these holes.
RAD-50
Card Protector
AR-200_e.book 11 ページ 2003年7月14日 月曜日 午後1時11分