iHome IH24 IB Manuel D’Utilisation

8

Symptom                          Possible Problem                                                    Solution

Unit doesn’t respond
(no power)

AC adaptor isn’t plugged into a wall outlet 
or the connector is not plugged into the 
power supply jack on the back of the unit

Plug the AC adaptor into a wall outlet and plug the 
connector into the supply jack on the unit

Wall outlet is not functioning or switched off

Plug another device into the same outlet to confirm the outlet 
is working. Make sure any associated power switch is ON.

iPod does not dock 
properly

Using no or wrong iPod insert

Make sure the dock insert is the proper fit for your iPod

iPod not installed properly

Remove your iPod from the dock and check for 
obstruction on the connectors in the dock and on your 
iPod. Make sure there is no “skin” or case on the iPod. 
Then reseat it in the dock.

Battery Low icon 
always flashing

Batteries are weak

Replace with new batteries

Batteries were not installed properly

Operating on battery power

Unit must be running on AC power to charge iPod. It will not 
charge your iPod when operating on battery power.

Check to make sure the polarity ( + and – ends) matches 
the diagram in the battery compartment

iPod does not 
charge 

iPod does not 
respond to the unit 

iPod is not installed properly

Remove your iPod from the dock and check for 
obstruction on the connectors in the dock and on your 
iPod. Then reseat it in the dock.

Your iPod software is too old

Upgrade software on your iPod via iTunes

iPod is locked up 

Please make sure your iPod is working properly before 
docking into the unit. Please refer to your iPod manual for 
details.

Using 1

st

 or 2

nd

 generation iPod, iPod 

shuffle or other devices.

iH24 cannot control those iPods or other devices.

Travel Lock is in Lock position

Move Travel Lock to Off or Remote position

Batteries are weak or dead

Replace with new batteries

If your iPod is not used for some time, it 
may enter deep sleep mode

iPod battery is too run down/weak

Press the Menu button on your iPod

Charge your iPod for about 5 minutes

Buttons/Controls 

don’t work

iPod does not come

on immediately

1

Connect AC adaptor cable to 

jack on back of the IH24 and 

plug the other end into a wall 

socket to play and charge iPod.

For portable operation, open 

battery compartment on the 

bottom of the unit.  Insert 4

“AA” (LR) batteries as indicated.

For this iPod

Use this insert

iPod nano 4G 

insert  17

iPod nano 4G 

thin iPod with video (30 GB)

Insert 9

thin (30 GB) iPod with video

thin (80GB) iPod classic

iPod Touch 2G

iPod touch 2G 

insert 16

RESETRESET

TESTTEST

Fold out the support stand feet 

located on the bottom of the unit

Insert iPod

®

  into dock (iPod must 

not be in a “skin” or case). When 

connected to AC power, iPod will 

charge while docked. Press the 

iPod/play Button on the IH24 to 

play your iPod. 

Select the dock insert for your 
iPod

®

 model from the table 

below and place insert in dock.
Never dock an iPod without 
the proper insert in place.