iHome iH30 Manuel D’Utilisation

If you are using an iPod without a docking port or other MP3 player or other portable audio device, you can 
still play it through the iH30 via the Line-in Jack.
1.  Plug one end of the audio patch cord (included) into the headphone or line-out jack on your device and the 

other end of the patch cord into the iH30 

 Line-in Jack, located on the front of the unit.

2. Press 

 Power On/Off Button on main unit or remote to turn iH30 on.

3. Press the 

 Mode Button until you can see “AU” showing on the display, indicating AUX playing mode.

4. Press the 

 Volume+ and  Volume– Button on main unit or remote control to adjust the system 

volume. You may need to adjust your device volume too.

5.  To turn off the unit, press the 

 Power On/Off Button on main unit or remote control to turn it off. Please 

remember to turn off your device, too.

Note: Extend FM rod antenna fully for best reception. In some areas, it may be difficult to get stereo sound 

without interference. If this proves a problem, set the Mono/Stereo FM switch on the back of the unit to 
Mono. 

1. Press the 

 Power On/Off Button on the iH30 or remote to turn unit on.

2. Press the 

 Mode Button on the iH30 or remote control until you can see a radio frequency showing on 

the display. 

3. Use 

 Tune Up or  Tune Down Button to tune in to the desired station. 

4.  Press and hold the 

 Tune Up or  Tune Down Button for appox. 2 seconds, it will start to auto seek 

available stations and will stop when a clear one is found.

5. Press the 

 Volume+ and  Volume– Button on the iH30 or remote control to adjust the iH30 volume. 

Press the 

 Mute Button to mute the output; press the button again to release it.

6.  To turn off the unit, press the 

 Power On/Off Button on the iH30 or the remote control to turn it off.

12