iHome iH22 Manuel D’Utilisation

Snooze Operation
1. Press and hold the Snooze/Dimmer Button for a few seconds to set snooze time. Press the     or       Button to set 

the snooze timer from 1 to 30 minutes.

2. Press the Snooze/Dimmer Button after the alarm sounds. The alarm will be silenced and come on again after the set 

snooze time. Snooze can be pressed several times during the 1 hour alarm cycle.

The iH22 has a sure alarm feature. If backup batteries are installed, the buzzer alarm will still sound in the event of power 
failure.

 Please make sure you are using the correct insert for your iPod (see Installing iPod Insert) and that the iPod is properly 

docked into the iH22. Failure to do so may damage your iPod.
1. While your iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged).  Back up 
batteries will NOT charge iPod. Note that non-docking iPod models will NOT charge.

1.  Dock your already playing iPod. The iH22 will automatically turn on and you will hear the music playing from your iPod. 

If the volume on the playing track is too low, iH22 may not detect that your iPod is in play mode. If this happens, 

press the       Button on the main unit to play it.

2.  When the iPod is docked and in standby mode, press the      Button on the iH22 to play it. The      will appear on the 

display, indicating iPod play mode.

3. Press the       Button again to pause play; press again to resume it.
4. Press the 

Volume       and Volume      Button to adjust the system volume.

5. Press the      or      Button on the  unit to go to the next or previous track. Press and hold while a track is playing for 

high speed forward or reverse music search of the current track. 

6.  To turn off the unit, press the     Button. The iPod will continue charging while in the dock.
Listening to non-docking iPod or other portable audio devices

If you are using an iPod without a docking port or another MP3 player or portable audio device, you can play it through the 
iH22 via the MP3 Line-in Jack located on the back of the unit.

1.  Plug one end of an audio patch cord (available at www.ihomeaudio.com) into the headphone or line-out jack on your 

device and the other end of the patch cord into the iH22 MP3 Line-in Jack. 

2. Press the      Button to turn the iH22 on.
3.  Turn on and play your device.
4. Press the 

Volume        and Volume      Button to adjust the system volume. You may need to adjust your device volume, 

too.

5.  To turn off the unit, press the      Button. Please remember to turn off your device, too.

5