iHome iH27 Manuel D’Utilisation

5

The remote control battery is already installed at the factory. When the remote control 

stops operating or its range seems reduced, replace the battery with a new one.
1. The battery door is located on the back end of the unit.
2.  Slide the battery door to release the battery door latch and remove the battery door.
3.  Insert a “CR2032” 3-volt lithium battery. Make sure the polarity (the + and – side of 

the battery) is correct.

4. Replace the battery compartment door back in the remote control.

The Remote Control controls basic functions on the iH27 and certain iPod® functions when the iPod® is docked in the iH27. 

For best results, aim remote control towards the remote sensor by the lower right corner of the display.

Move the  Travel Lock Switch to Remote position to enable the remote control.  

 

6

Turns iH27 OFF or resets alarm when alarm is sounding 

Selects iPod and plays track. In play mode, press to pause

Toggles sound ON or OFF

Turn SRS WOW sound enhancement ON or OFF

Selects Sleep Time function

Snooze mode when alarm sounds, otherwise dims display

Lowers volume level

Raises volume level

Skip to previous or next track when iPod is playing, or
hold to scan current playing track.

Install/Replace Backup Battery
The iH27 uses a backup battery system to provide continuous alarm operation and 

clock settings in the event of a power failure. If the Backup Battery Low Icon located 

on the left of the display is flashing, it is time to replace the backup batteries. Please 

make sure the AC adaptor is connected, otherwise all settings may be lost during 

battery replacement.
Open the battery compartment cover located on the bottom of the unit in the left 

battery compartment. Insert 1 “CR2032” battery as indicated. Replace battery 

compartment covers. 

Battery install for

Clock display back up

The iH27 uses 4 “AA” batteries for portable playing. If sound becomes weak or 

distorted while operating on batteries, it’s time to replace the batteries.The iH27 will 

not charge iPod while operating on batteries.
•  Open the battery compartment covers located on the bottom of the unit. 
•  Insert 2 AA batteries in each compartment as indicated, making sure the polarity 

(+ and -) matches the diagram. 

•  Replace battery compartment covers.

•  Do not mix old and new batteries.
•  Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium) 

batteries.