iHome iH12 Manuel D’Utilisation

1.  Press and hold the 

Alarm-1 or Alarm-2 Button until the alarm time blinks in the lower part of the display. Press the << 

or 

>> Button to set the alarm time. Holding the button for a few seconds will advance or reverse rapidly. Remember to 

set the correct AM or PM time. 

2. Press 

the 

Wake-to Button to select iPod, Radio or Buzzer alarm source. You can set different alarm sources for each 

alarm.

3.  Press the Alarm Button again or wait for 10 seconds. Alarm is now armed, indicated by the numbered alarm clock icon.
Review, Arming and Disarming Alarm (Turn Alarm Function On and Off)

1. Press 

Alarm 1 (or Alarm 2) Button once. The unit will show the alarm time on the bottom part of the display for alarm 

time review.

2.  During alarm review, press the Alarm 1 or Alarm 2 button again to arm or disarm the alarm. When the alarm is armed, 

the related alarm icon appears in display.

1.  When the alarm is sounding, press the 

Alarm Reset/Power On/Off Button to stop the alarm and reset it to come on 

the following day at the same time.

1. Press 

the 

Snooze/Dimmer Button after the alarm sounds. The alarm will be silenced and come on again 9 minutes 

later. Snooze can be press several times during the 1 hour alarm cycle.

The iH12 has a sure alarm feature. If backup batteries are installed (see page 3) the buzzer alarm will still sound in the event 
of a power failure.

6

Note: Please make sure you are using the correct insert for your iPod (see Install iPod Insert) and that it is properly docked 
into the iH12. Failure to do so may damage your iPod.

1.  While your iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged). Note that  

non-docking iPods will NOT charge.