ADC ML-96 Manuel D’Utilisation

FOR PHASE 6 MODELS

This dryer was manufactured with a manual reset burner hi-limit and tumbler/lint chamber hi-limit thermostat

which is monitored by the Phase 6 computer.  If either manual reset thermostat is open prior to start of the drying

cycle, the dryer will start momentarily and then shut down, the Phase 6 computer will display an error code with

an audio indication.  If the tumbler/lint chamber hi-limit thermostat is open, the display will read “dRUM SAFETY

FAIL.”  If the burner hi-limit thermostat is open, the display will read “bURNER SAFETY FAIL.”

If either manual reset hi-limit thermostat opens during a drying cycle, the display will show the applicable error

code described above along with an audio indication.  If the drum temperature is above 100º F (38º C), the dryer

will continue to run with no heat for three (3) minutes or until the drum temperature has flattened below 100º F

(38º C).  The clear/stop button on the Phase 6 keypad (touchpad) must be pressed to clear the error condition.

The open manual reset hi-limit thermostat must be reset “manually” prior to the start of the next cycle.

This hi-temperature condition may be caused due to a restricted exhaust, poor airflow or improper burner operation.

The location of the burner hi-limit is on the right side of the burner box and the tumbler hi-limit is located in the lint

chamber area.

WARNING: Discontinue power to dryer before attempting to reset hi-limit.

This dryer is equipped with a burner

hi-limit and tumbler/lint chamber hi-limit
thermostat which must be reset manually.

WARNING: Discontinue power to dryer
before attempting to reset hi-limit.