Beko DC 7100 Manuel D’Utilisation

6 EN

This section includes safety information that will 

help protection from risks of personal injuries 

or materialistic damages. Failure to follow 

these instructions shall cause any warranty and 

reliability commitment to become void.

•  Never place the machine on a carpet-covered 

floor, otherwise, lack of airflow beneath 

the machine may cause electrical parts to 

overheat. This will cause problems with your 

machine.

•  If the power cable or mains plug is damaged, 

you must call Authorised Service Agent for 

repair.

•  The product should not be plugged in during 

installation, maintenance and repair works. 

Such works should always be made by the 

technical service. Manufacturer shall not 

be held responsible for damages arising 

from processes carried out by unauthorised 

persons.

•  Connect the product to a grounded outlet 

protected by a fuse of suitable capacity as 

stated in the technical specifications table.

•  Operate your product at temperatures 

between +5°C and +35°C.

•  Do not use electrical devices in the product.

•  Do not connect the air exit of the product 

to the chimney holes which are used for the 

exhaust fumes of the devices operating with 

gas or other types of fuel.

•  You must provide enough ventilation in 

order to prevent gases exiting from devices 

operating with other types of fuels including 

the naked flame from accumulating in the 

room due to the back fire effect.

•  Always clean the lint filter before or after each 

loading.

•  Never operate your dryer without the lint filter 

installed.

•  Do not allow fibre, dust and dirt accumulation 

around the exhaust exit and at adjacent 

areas.

•  Power cable plug must be within easy reach 

after installation.

•  Do not use extension cords, multi-plugs 

or adaptors to connect the dryer to power 

supply in order to decrease the risk of electric 

shock.

•  Do not make any changes on the plug 

supplied with the product. If it is not 

compatible with the socket, have a qualified 

electrician change the socket with a suitable 

one.

•  Items cleaned or washed with gasoil/fuel oil, 

dry-laundry solvents and other combustible 

or explosive materials as well as the items 

that are contaminated or spotted with such 

materials should not be dried in the product 

since they emit flammable or explosive vapor.

•  Do not dry items cleaned with industrial 

chemicals in the dryer.

•  Do not dry unwashed items in the dryer.

•  Items soiled with cooking oils, acetone, 

alcohol, fuel oil, kerosene, stain remover, 

turpentine, paraffin and paraffin removers 

must be washed in hot water with plenty of 

detergent before being dried in the dryer.

•  Garments or pillows bolstered with rubber 

foam (latex foam), shower bonnets, water 

resistant textiles, materials with rubber 

reinforcement and rubber foam pads should 

not be dried in the dryer.

•  Do not use fabric softeners and anti-static 

products unless they are recommended by 

the manufacturers of the fabric softener or 

the product.

•  This product must be grounded. Grounding 

installation decreases the risk of electric 

shock by opening a path with low resistance 

for the electricity flow in case of a malfunction 

or failure. Power cable of this product is 

equipped with a conductor and a grounding 

plug that allows for grounding the product. 

This plug must be installed appropriately and 

inserted into a socket which is grounded 

in accordance with the local laws and 

regulations.

•  Do not install the product behind a door with 

a lock, sliding door or a door that has a hinge 

against the hinge of the dryer.

•  Do not install or leave this product in 

places where it will be exposed to outdoor 

conditions.

•  Do not tamper with the controls.

•  Do not perform any repair or part replacing 

procedures on the product even if you know 

or have the ability to perform unless it is 

clearly suggested in the operating instructions 

or the published service manual.

•  Inside and exhaust duct of the product must 

be cleaned by the qualified service personnel 

periodically.

•  Wrong connection of grounding conductor 

of the product can cause electric shock. If 

you have any suspect about the grounding 

connection, have it checked by a qualified 

electrician, service representative or service 

personnel. 

•  Do not reach into the machine when the 

drum is spinning.

•  Unplug the machine when it is not in use.

•  Never wash down the appliance with water!