Hotpoint TCYM 80C Manuel D’Utilisation

Dryer Description

Installation

You 

 empty the water container  

after 

 drying cycle.

Removing the water container:

Pull the water container towards you and remove it completely 

from the dryer.

Empty all the water in the water container.

Replace the water container making sure that it is securely fixed. 

When your dryer is new, the water container will not collect 

water until the system is primed. This will take 1 or 2 drying 

cycles. Once primed it will collect water during every drying 

cycle.

You 

 clean the fluff from the 

condenser 

 month. Failure to  

clean the condenser could cause 

premature failure of your dryer.

Remove the condenser unit regularly (at least monthly) and clean 

off any fluff deposits.

Open the condenser cover.

Remove the condenser 

by turning the 3 catches 

and pulling the condenser towards you. It is 

normal for some residual water to be left in 

the condenser unit.

Flush the condenser from the rear with water 

to remove any fluff deposits.

Replace the condenser unit and make sure 

that all 3 catches are closed and that the 

position arrows on the front of the condenser 

are pointing upwards.

If you are going to install the dryer 

under a work counter be sure to leave 

a 10mm space between the top and 

any other objects on or above the 

machine and a 15mm space between 

the sides and any kitchen units or 

walls to ensure proper air circulation.

The dryer must never be installed 

behind a lockable door, a sliding door 

or a door with a hinge on the opposite 

side to that of the dryer door.

If the dryer is installed next to a drain 

the water can be plumbed into this 

drain. This does away with the need to 

empty the water container. The height of 

the drain must be less than 1m from the 

bottom of the dryer. Remove the existing 

hose from the dryer and connect it to 

the drain (if required add an additional 

length of hose).

The socket must be grounded. The power supply cord should be 

checked periodically and, if required, replaced by a cord specially 

prepared for this dryer.

Once you have installed your dryer and before you use it clean 

the inside of the drum to remove any dust that could have 

accumulated during transport.

10

 m

m

15 mm

15 mm

15 mm

15 mm

20

30

40

50

60

70

801

001

10

120

130

Knob Indicator

Button

Button

Light

The 

HEAT 

button selects drying temperature.

 heat 

 heat

The 

knob sets the drying time: rotate it clockwise, 

, until the indictor is pointing to the drying 

time you want to select.

The Empty Water indicator light signals that the water container is 

full and must be emptied. The light will take a few seconds to go 

out after replacing the empty water container, the dryer must be 

running for this to happen.

Note: If the water container fills up the indicator lights, the heat is 

turned off and your laundry will not dry.

2

2

1

Less than 1m