Blomberg TKF 9431 A Manuel D’Utilisation

5 EN

Refer to the nearest Authorised Service Agent 
for installation of your product.

C 

Preparation of location and electrical 
installation for the product is under 
customer’s responsibility.

B

Installation and electrical connections must 

be carried out by a qualified personnel.

A

 Prior to installation, visually check if the 

product has any defects on it. If so, do not 
have it installed. Damaged products will 
cause risks for your safety.

•  Install the product in an environment which 

has no risk of freezing and is in a stable and 
level position.

•  Operate your product in a well ventilated, 

dust-free environment.

•  Do not block the air ducts in front of and 

under the product with materials such as 
long pile rugs and wooden bands.

•  Do not place your product on a long pile rug 

or on similar surfaces.

•  Do not install the product behind a door 

with a lock, sliding door or a hinged door 
which can strike the product.

•  Once the product is installed, it should stay 

at the same place where its connections 
have been made. When installing the 
product, make sure that the rear wall of it 
does not touch anywhere (tap, socket, etc.) 
and also pay attention to install the product 
at a place where it will stay permanently.

B

 Do not place the product on top of the 

power cable.

•  Keep at least 1.5 cm distance to walls of 

other furniture.

A

Remove the transportation safety assembly 

before using the product for the first time.

1.  Open the loading door.
2.  There is a nylon bag inside the drum that 

contains a piece of styrofoam. Hold it from 
its section marked with XX.

3.  Pull the nylon towards yourself and remove 

the transportation safety assembly.

A

Make sure that you have removed 

the transportation safety assembly 
(nylon+styrofoam pieces) before using the 
product for the first time. Do not leave any 
items inside the drum.

•  A special part (Part no. 297 360 0100) 

replacing the top trim must be provided and 
installed by the Authorised Service Agent in 
order to use the machine under a counter or 
in a cupboard. It should never be operated 
without the top trim.

•  Leave at least 3 cm of space between 

the side and rear walls of the product and 
the walls of the counter/cupboard when 
installing your product under a counter or in a 
cupboard.

•  A fitting device should be used between 

the two machines when installing above a 
washing machine. The bracket (Part no. 297 
720 0100 white/297 720 0400 grey) must be 
installed by the Authorised Service Agent.

•  Place the product on a firm floor. If it will be 

placed on top of a washing machine, the 
approximate weight of both machines may 
reach 180 kg when they are full. Therefore, 
the floor must be capable of carrying the load 
on it!

In products equipped with a condenser unit the 
water accumulated during the drying cycle is 
collected in the water tank. You should drain the 
accumulated water after each drying cycle.