Sony UP-DF500 Manuel D’Utilisation

O

per

at

ion

Loading Film

11

The following blue thermal film is made especially for 
the UP-DF500.

Contains blue thermal transparent film.
125 sheets of 14 × 17 inch film
Be sure to use film made expressly for the UP-DF500. If 
you use other film, the quality of the printout cannot be 
guaranteed. Use of another type of film may also cause 
malfunction of the unit.

Proceed as follows to load film sheets.
If you use the unit immediately after purchase, start 
operations from step 2.

The remaining film confirmation indicator allows you to 
confirm the amount of film remaining.
When this indicator is not lit, film has run out. Load new 
film.

• Hold the film using the aluminum damp-proof bag. Do 

not touch the film directly. Dust, finger prints, or sweat 
are likely to cause unsatisfactory printing.

• Hold both sides of the film tray and tray cover tightly 

when handling the film tray.

Push the EJECT TRAY button on the front panel.

The film tray is partially ejected.

• You can replace film without pulling out the film 

tray completely out. However, if you want to pull 
out it completely, hold both sides of the film tray 
and film tray cover firmly.

• The film tray can not be ejected while printing or 

when the covers are open.

Open the film tray cover by putting your fingers in 
the grooves on both sides of the film tray, and 
pulling it upward in the direction of the arrow.

If the old printing surface protection sheet remains 
in the film tray, remove it. 

Remove the aluminum damp-proof bag from the 
film carton.

Remaining film confirmation window

Push the EJECT TRAY button

Pull it upward in the direction of the arrow, 
putting your fingers in the grooves.