ARRI 416 Manuel D’Utilisation

Page de 240
 
Overview of Display Modes 
Mode 1 is displayed: 
after switching on the camera, 
after pressing the “RUN” button 
or 30 seconds after the last operation.
 
1st Display Line 
2nd Display Line 
Adjustment Possibility
Mode 1 
total exposed film counter (m/ft) or 
frame rate (fps) or 
setting/re-setting of total exposed film counter
 
take counter (m/ft) 
ESU in standby and 
selection of a standard frame rate
 
 
frame rate (fps) while running  
 
 
(external control connected) 
Mode 2 
programmed frame rate (PS) 
programmed frame rate (fps) 
programmed frame rate
 
ESU – external control connected 
 
Mode 3 
total exposed film counter (m/ft) or 
power supply voltage (V), or (with 
unit of measurement (m/ft)
 
take-counter (m/ft) 
OBB-2 fitted) capacity in percent 
configuration of the film counter 
 
 
or remaining magazines 
press SET to set battery warning level
Mode 4 
timecode hours:minutes 
timecode seconds:frame rate 
press and hold SET for 3 seconds to turn TC on/off
 
press SEL to show TC error codes 
press SEL to show TCS settings 
press and hold SEL and then 
 
 
and activity of clock adjustment 
press and hold SET for 3 seconds to reset clock 
 
 
 
adjustment to default
Mode 5 
timecode user bits (1st 4 digits) 
timecode user bits (2nd 4 digits) 
setting of user bits (0-9, A-F) 
Mode 6 
sequence and volume of the acoustic 
brightness of the keypad 
beep at start, stop, neither or both 
 
warning signal 
 
beeper volume 
 
 
 
keypad backlight brightness 
Mode 7 
GLo – RGB ARRIGLOW 
ARRIGLOW color 
preset colors 1-8 and User adjustable color 
 
 
r, G & B values (0-16) for User color 
r, G & B values (0-16) for User color
Camera
Operation