Nikon S3200 Manuel D’Utilisation

E

Refere

The following table lists the error messages and other warnings displayed in the 
monitor, as well as the solutions for dealing with them.

Display

Cause/Solution

A

O (flashes)

Clock not set.
Set date and time.

Battery exhausted.

Charge or replace the battery.

14, 16

Battery temperature 
high

Battery temperature is high.
Turn off camera, and allow battery to cool down before 
resuming use. After five seconds, the monitor will turn off 
and the power-on lamp will flash rapidly. After the lamps 
flash for three minutes, the camera will turn off 
automatically. Pressing the power switch also turns off 
the camera.

The camera will turn 
off to prevent 
overheating.

The camera has become hot.
The camera turns off automatically. Leave the camera off 
until it has cooled and then turn it on again.

Q (

● flashes red)

Camera cannot focus.
• Refocus.
• Use focus lock.

26, 29
67

Please wait for the 
camera to finish 
recording.

Camera cannot perform other operations until recording 
is complete.
Wait until message clears from display automatically 
when recording is complete.

–

Memory card is 
write protected.

Write-protect switch is in “lock” position.
Slide write-protect switch to “write” position.

–

Not available if Eye-
Fi card is locked.

Write-protect switch of Eye-Fi card is in “lock” position. 
Slide the write-protect switch to “write” position.

–

Error accessing Eye-Fi card.
• Use an approved card.

• Check that terminals are clean.
• Confirm that Eye-Fi card is correctly inserted.

E66
18
18

This card cannot be 
used.

Error accessing memory card.
• Use approved card.

• Check that connectors are clean.
• Confirm that memory card is correctly inserted.

19
18
18

This card cannot be 
read.